du line fieldbus installationbus specifications are subject to change without notice (12.10.05) 1 dupline is a registered trademark. a product of the carlo gavazzi group 4-digit 7-segment led-display with sign freely scaleable 2 relay limit outputs (hi, lo) 2 npn transistor limit outputs (hihi, lolo) led-indication for all limit outputs automatic or manual reset of limit outputs protocol selectable (3 1/2-digit bcd, 4-digit bcd, 8 bit binary) multiplex or normal mode internal or external selection of multiplex address ? ac power supply product description freely scaleable dupline 4 digit led-display with sign, for panel mounting. readout of analog signals, counter values or time. 4 limit outputs with led-indication. protocol selectable (3 1/2 digit bcd, 4-digit bcd, 8 bit binary) type selection supply ordering no. 8/16 channels 4-digit led 24 vac d 6369 6475 024 115/230 vac d 6369 6475 230 no code module required input/output specifications inputs limit output reset 1 contact or npn transistor multiplex address selection 4 contacts or npn transistors open loop voltage 5 vdc short circuit current 50 ? contact resistance 10 cable length 2 m dielectric voltage inputs - dupline 500 vac (rms) inputs - relay outputs 4 kvac (rms) inputs - transistor outputs 4 kvac (rms) hi, lo - limit outputs 2 spst relays isolated in groups of 2 x 1 contact ratings (agcd0) (micro gap) resistive load ac1 5 a/250 vac (1100va) dc1 0.25 a/250 vdc (62 w) or 5 a/25 vdc (125 w) inductive loads ac15 2.5 a/230 vac dc13 5 a/24 vdc mechanical life 30 x 10 6 operations electrical life (max. load)ac1 2.5 x 10 5 operations operating frequency 7200 operations/h dielectric voltage outputs - dupline 4kvac (rms) outputs - transistor outputs 4kvac (rms) type: dupline type no. supply ordering key display receiver with limit outputs type d 6369 6475 d 6369 6475 024 display display format 7-segment display range -9999 to +9999 (4 digits) display type led height of digits 14.2 mm display colour red change of sign (automatic) yes decimal point configurable by keys scaling feature yes multiplex feature yes display test yes transmission protocol 3 1/2, 4-digit bcd, 8 bit binary limit values 4 (hihi, hi, lo, lolo) settings channel address keys and display multiplex address (internal) keys and display scaling keys and display decimal point position keys and display limit values keys and display normal/multiplex mode keys and display enable/disable limit outputs keys and display transmission protocol 2 dip switches internal/external selection of multiplex address 1 dip switch automatic/manual reset of limit outputs 1 dip switch
du line fieldbus installationbus 2 specifications are subject to change without notice (12.10.05) dupline is a registered trademark. a product of the carlo gavazzi group power supply overvoltage cat. iii (iec 60664) rated oprational voltage 230 115 and 230 vac 15% 024 24 vac 15% frequency 45 to 65 hz dropout tolerance 4.5 ms rated operational power typ. 8 va rated operational withstand voltage 230 4 kv 024 800 v dielectric voltage supply - dupline 4 kvac (rms) supply - inputs 4 kvac (rms) supply - relay outputs 4 kvac (rms) supply - transistor outputs 4 kvac (rms) d 6369 6475 general specifications power on delay 3s indication for hihi limit output led, red hi limit output led, yellow lo limit output led, yelow lolo limit output led, red environment degree of protection ip 20 pollution degree 3 (iec 60664) operating temperature 0 to + 60? (+32 to +140?) storage temperature -25 to +85? (-13 to +185?) humidity (non-condensing) 0 to 80% mechanical resistance shock 15 g (11 ms) vibration 2 g (6-55 hz) material glass-reinforced noryl weight 460 g approvals ul, csa supply specifications mode of operation 4-digit 7-segment led dis- play used to monitor analog signals, counter values or time of the day. the display value is freely scaleable within the range -9999 to +9999 with select- able position of the decimal point. values from 3 1/2-digit bcd, 4-digit bcd and 8-bit binary transmitters can be displayed, since the trans- mission protocol is select- able. 4 limit outputs are available: hi, lo -relay outputs hihi, lolo -npn transis- tor outputs each output can be allocated freely to any scaled display value. the limit outputs turn on whenever the value con- trolling the outputs is equal or above the limit value setting for hi and hihi (equal or below for lo and lolo). it is selectable whether the limit outputs shall be reset automatically (by the value controlling the limit outputs returning to normal) or man- ually by activation of the "limit reset" - input. the limit outputs may also be disabled if this feature is not required. 4 leds at the front also indicate the signal level com- pared to the 4 limit settings, blinking upon limit alarm, steady state after a manual reset. the display can be used in normal mode as well as in multiplex mode (3 1/2- digit bcd protocol only). when used in multiplex mode, the multiplex address for the display may be selected by a selector switch (e.g. on the cabinet door) that connects to the "multiplex address" inputs. each of the display values from the 16 multiplex addresses can be scaled individually. the limit value setting however will always refer to the multiplex address defined during the configuration. with the 4 keys at the front the display shifts to program mode, in which scaling, dec- imal point position, limit value settings, channel address, multiplex address etc. is con- figured. for further information please refer to the "user manual" delivered with the unit. display specifications hihi, lolo limit outputs 2 npn transistors watchdog-output 1 npn transistor isolated in groups of 1 x 3 output voltage range v bb 6-60 vdc reverse-polarity protection none current per output 250 ma total load capability 100% short-circuit protection none built-in protective diodes none off-state leakage current 500 ? output voltage drop 2.5 v dielectric voltage outputs-dupline 4 kvac (rms) response time multiplex input 1 pulse train reset inputs 1 pulse train limit outputs 1 pulse train watchdog output 1 pulse train
du line fieldbus installationbus specifications are subject to change without notice (12.10.05) 3 dupline is a registered trademark. a product of the carlo gavazzi group d 6369 6475 settings multiplex address selection inputs multiplex multiplex address address input terminals 0 0000 1 0001 2 0010 3 0011 4 0100 5 0101 6 0110 7 0111 8 1000 9 1001 a 1010 b 1011 c 1100 d 1101 e 1110 f 1111 msb lsb functional description watch dog hihi output common lolo output lo output hi output dupline signal dupline multiplex input for readout reset input power supply dimensions (mm) wiring diagrams power supply programming keys dip-switch for function selection panel cut-out panel thickness
|
